Application is key to get the best results from freezeframe

DIRECTIONS

1. Clean the area & rinse thoroughly with water making sure that all residue is removed. Pat dry.

2. To unlock the syringe gently turn the plunger in an anticlockwise direction until you feel a click. Pump the syringe a few times to get the serum flowing.

3. Take the syringe & pump once onto your forefinger. A little goes a long way so one pump should cover crows feet on both eyes as well as glabular (frown lines) and forehead lines. Use a small amount of freezeframe® and spread over the area following the wrinkle in one direction. Do not pat, dab or rub back and forth. If you experience difficulty applying by hand, great results can be achieved by applying with a concealer brush following the wrinkle lines in one direction. Experiment and see what works best for you.

4. Freeze. Avoid moving your face for 2-3 minutes or until freezeframe® has completely dried. You will feel a tightening sensation as freezeframe® goes to work. This should not be uncomfortable and will subside after a few minutes.

5. Layering. You may layer freezeframe® for a stronger hold once the first layer is completely dry.

Moisturiser:
Should you wish to use a moisturiser apply it before applying freezeframe®, allow it to soak into your skin then remove any residue by washing the area and follow the directions above.


Makeup:
Once freezeframe® has dried you may apply a mineral makeup, or an oil free makeup. freezeframe® must not come in contact with oil as this may cause the product to flake or diminish the tightening effect. If using a water based formula, pat over the area with a cosmetic sponge. Do not apply too much pressure. Never rub or touch the area after application, as this will cause cracking and/or flaking.

REMOVAL
To remove freezeframe®, you should only use clean water. Do not use cleansers or makeup removers and do not rub off. Either splash the area with water until all tracers of freezeframe® are removed, or soak a cotton ball or pad with water and apply to the area to disperse the product. Be gentle and never rub the area.

TROUBLESHOOTING
White lines – if you notice a slight whitening around the edges simply apply a thin layer of freezeframe® to the area of concern or use a moist cotton bud to blend away.
Flaking – flaking is a result of using too much product. If this occurs remove product as directed above and commence application again.
Clogging – rinse the tip under warm water to avoid clogging. If you notice white particles in the serum remove the tip and rinse under warm water. Remove excess water and replace tip back on syringe.

WARNING
Keep out of reach of children.
For external use only.
*    Avoid contact with eyes. If product gets into eyes, rinse thoroughly with cold water.
*    Never apply to upper eyelid.
*    Do not apply to broken, inflamed, sun burnt or irritated skin.
*    If skin irritation occurs, discontinue use.

freezeframe® is not always suitable for very sensitive skin. If in doubt, patch test a small area of skin just below your ear before applying to face.
This product may have a slight whitening effect and may not be suitable on darker skin tones.